hello all!
i just recently bought a dash overlay from rimmer brothers
and when i went to test the fit on my dash, i noticed that
it doesn't quite sit down flat on the dash. it seems like
the front edge (the edge under the windshield) is bottoming
out and not allowing the coverlay to conform to the right
contour of the dash. my question goes out to ask if anyone
else encountered this with a dash overlay that they've
installed. did you have to trim it to make it fit better?
if so, how did you trim it? is this just something that
i'll have to get over and leave it as it is? when i install
the demister vents, it make the overlay bend and flex and
leave gaps under the vents. it doesn't really look that
good.
thans in advance for any replys.
==
nikolai jaremka
72 spitfire mkIV
east aurora, new york
|