Bowen, Patrick A. RP2 wrote:
> Okay, so I am now tediously beginning the job of removing my floor pans to
> be replaced. i have started drilling out some of the spot welds and
> thought I should stop and ask some advice. Is it bad to drill all the way
> through both panels? I have not been able to consistently drill out the
> welds, without doing this. How do you repair this later when you have a
> hole staring at you.
Patrick:
What you need is a spot weld cutter, sort of a hollow centered drill that cuts
*around* the spot weld, leaving the welded center attached to the intact panel
below, which you then grind off.
(Sorry, mine's in the hands of a buddy or I'd lend it to you....)
John
|