In a message dated 7/4/98 6:40:46 PM Eastern Daylight Time,
ajb23@dunx1.ocs.drexel.edu writes:
> I was fortunate enough to end up with the $70 it took to grab a set of
> matching locks from Vickie Brit recently, but I am curious as to how to
> replace the door locks... They seem impossible to get to first thing (the
> openings in the doors are very limited) and I havent a clue how to
> remove/replace them. The Haynes manual shows me how to remove the actual
> latch part, but not the lock. Any ideas would be helpful.
If I recall when I did my GT6 you have to remove the locking mechanism and
remove the bar that goes from the interior door hadle(held in by a pin clip).
That should clear up some space. Now just squeeze the two slots that hold in
the keylock and pop it out. That part I found a pain, but I was able to pry
the locks out from the out side since my car is not painted yet.
Best of Luck,
Tom
|