jfkoper1@aol.com wrote:
>Any guidelines for routing the back e-brake cables? The Helms diagrams are not
>super clear, and I think the previous set were not optimally routed, causing
>premature 'stuck caliper.' I'd release the e-brake and the pivot mechanism on
>the calipers would not move at all. This time I am trying a 'looser' routing
>so the cable bend is not too severe when going in to the caliper hole.
>However, this has my passenger side rear hanging down 6" below the rear
>control arm. Is that normal/acceptable?
>
>
The factory used some clip to hold the cable to the rear control arm.
Use a nylon cable tie.
- Tom Teixeira, former SHO owner (94 MTX, 91 Plus)
_______________________________________________
Shotimes mailing list
Shotimes@autox.team.net
http://www.team.net/mailman/listinfo/shotimes
|