>There is no way for 90 V to get to the headlight switch!! It's only 12 VDC
>until you get inside the HID assembly and the ballast takes over. So no it
>won't put high voltage on your headlight switch wiring!
While this may not be the typical failure mode for HID modules (been mentioned
already that they tend to short internal to the voltage coil), I've seen enough
power supplies short back to the input via regulating components, feedback
loops, and even shorted windings to know that what I stated is quite possible.
Knowing this, I cannot consciously give advice to anyone to preclude their own
safety.
David
_______________________________________________
Shotimes mailing list
Shotimes@autox.team.net
http://www.team.net/mailman/listinfo/shotimes
|