i did mine on my front street,in town with a floor jack and hand tools with
an electric impact gun to get the old rusted clamps off.now they say without
a rod shifter it doesn't fit as well?that i don't know cause i have a plus
with a rod shifter so mine fit nicely.i also used ati-seize on all my joints
so when a part does go bad i won't have as hard a time to take it apart.BOB
----- Original Message -----
From: "Techpriest" <techpriest@ourlair.com>
To: "'SHO'" <shotimes@autox.team.net>
Sent: Friday, June 16, 2006 7:39 AM
Subject: RE: [Shotimes] dynomax (easy install)?
>I want to replace the exhaust on my 89 before it falls off on it's own. It
> is currently being held on with bailing wire and the mufflers have holes
> in
> them. Was thinking I would use a catless Y to save money since we don't
> cats in KS. I would go with Dynomax for the rest since it is the only
> complete exhaust kit available for the SHO that I have found. Is this the
> kind of job a non-mechanic could do with simple hand tools and a floor
> jack
> on a weekend? I do have an air compressor and impact tools, but no way to
> weld. I have got to make friends with somebody with a lift....
>
>> got my exhaust on,but not tightened.thing fits like the stock
>> exhaust.i had
>> actually more trouble getting the old,rusted one off.finally
>> got the hack saw
>> and fixed that LOL!only thing is the drivers side muffler
>> does sit a tad lower
>> so i'll have to adjust it slightly,but not much.thanks to all
>> of you for your
>> help.BOB
> _______________________________________________
> Shotimes mailing list
> Shotimes@autox.team.net
> http://www.team.net/mailman/listinfo/shotimes
_______________________________________________
Shotimes mailing list
Shotimes@autox.team.net
http://www.team.net/mailman/listinfo/shotimes
|