Small engine carbs seem to be impossible to clean. Other than an old
Briggs lawn mower, I've never had any luck. Chain saws, blowers,
string trimmers -- cheaper to replace them than to clean them. The
fuel pump diaphragm is the culprit, I think. Nearly impossible to get
right again.
On Fri, Jul 24, 2020 at 3:34 PM Scott Hall
<scott.hall.personal@gmail.com> wrote:
>
> I have a Troy Bilt 4-cycle backpack leaf blower, the older version of this
> thing:
>
> https://www.troybilt.com/en_US/leaf-blowers/tb4bp-ec-backpack-gas-leaf-blower/41BR4BEG766.html
>
> I need intelligent more experienced folks to advise me before I slip into
> insanity.
>
> The past year or so the choke has lost effectiveness--you used to start it as
> directed: pump the primer bulb a few times, choke on full. Start. Choke to
> 1/2 until warm, then choke full-off.
>
> At first it wouldn't start with choke full-on, I had to start it on
> half-choke. Then 1/4-ish.
>
> At the same time, the throttle became more of an an/off switch. It would bog
> at anything other than idle. If I open it full, it would die. And it never
> achieved full-power.
>
> Note: the choke is an actual choke--a plastic plate slides over the air
> intake on the carb.
>
> This sounds like something that needs a carb cleanin', right? So I did. Took
> it apart, soaked it in carb cleaner, re-assembled.
>
> I also replaced the fuel intake line and fuel filter--a weird little thing,
> looks like a pumice stone on the end of the fuel line.
>
> Worked...better. Not back to new, but better. For a day.
>
> Now it won't start at all.
>
> There's just not that much to this carb. I blew it out with compressed air,
> chased the passages I could, etc. There's just not much there...there.
>
> What's making me question my sanity is that this happened on my riding mower
> last year too and I similarly cleaned that carb, which was similarly simple
> and it absolutely would not run again until I just bought a new carb and
> replaced it.
>
> So here's the question: what am I doing or not doing that I can't clean a
> small engine carburetor? Is there some secret air passage on small engine
> carbs that I'm not reaching? I tool them completely apart. There were no idle
> jets, or enrichment circuits, or...whatever. Just a hunk of metal with a few
> small holes. What on earth would make the new one better than the one that's
> on there?
>
> I feel like this should be so simple and I'm missing something so basic.
> _______________________________________________
>
> Shop-talk@autox.team.net
> Donate: http://www.team.net/donate.html
> Suggested annual donation $12.96
> Archive: http://www.team.net/pipermail/shop-talk http://autox.team.net/archive
>
> Unsubscribe/Manage:
> http://autox.team.net/mailman/options/shop-talk/fishplate@gmail.com
>
_______________________________________________
Shop-talk@autox.team.net
Archive: http://www.team.net/pipermail/shop-talk http://autox.team.net/archive
|