thanks Jeff and John.... that was exacterly what I was looking for but never
googled 'sleeve' we tried to make one today but didn't have the
precision we needed (old lathe and dummy operators) Just ordered it and
on my way to H.F. for the engine...
thanks
John
-----Original Message-----
From: Jeff Scarbrough
Sent: Friday, November 06, 2015 11:05 AM
To: john niolon
Cc: shop-talk
Subject: Re: [Shop-talk] small engine shaft mismatch
Like this?
http://www.ebay.com/itm/like/380780662478?ul_noapp=true&chn=ps&lpid=82
or this?
http://www.zoro.com/dayton-bushing-reducer-pk3-2x775/i/G0315445/
-- Jeff
On Fri, Nov 6, 2015 at 11:07 AM, john niolon <jniolon@att.net> wrote:
> Good Morning Group...
>
> hereb s a thinking project for you this a.m.
>
> I have a 5hp Tecumseh engine thatb s giving up the ghost.. horizontal
> keyed
> shaft 1b diameter... it attaches directly to a vacuum unit (leaves) with
> an
> impeller with the same sized hole (of course).
>
> Every 5 hp engine Ib ve found is supplied with a 3/4b shaft... still
> searching for a 1b shaft engine but Ib m wondering if I could make a
> sleeve
> with a 1/8b wall thickness that I could use... I understand Ib d need a
> b thickerb key and that not be a big deal to make... what do you
> guys
> think about the sleeve... I could probably find a section of black pipe
> with
> close dimensions and make one...
>
> top speed is 3600 rpm at the shaft I think...
>
> think itb s doable ?? OR does anyone know of a manufactured shaft
> b sleeveb that I can buy ??
>
> thanks
> ]John
> _______________________________________________
>
> Shop-talk@autox.team.net
> Donate: http://www.team.net/donate.html
> Suggested annual donation $12.96
> Archive: http://www.team.net/archive
> Forums: http://www.team.net/forums
> Unsubscribe/Manage:
> http://autox.team.net/mailman/options/shop-talk/fishplate@gmail.com
_______________________________________________
Shop-talk@autox.team.net
Archive: http://www.team.net/archive
|