Do you know what the SCFM rating is at ~100 psi? That is more likely
where you'll want to set the pressure for sandblasting.
I suspect you've got an adequate air supply - especially for small
items in a small cabinet. More important is a supply of dry air.
Blasting does not like wet air. A run of metal pipe (copper or steel)
will encourage the air to cool down and the water to condense out. Plan
the air line leading to the cabinet such that it will not come off the
bottom of a run to keep water out.
See the air piping instructions at
http://www.tptools.com/StaticText/airline-piping-diagram.pdf
Eric Russell
Mebane, NC
Quoting John Niolon <jniolon@att.net>:
Ibve got a Quincy 310 compressor sitting on a 80 gallon tank... using a 5 hp
motor. Itbs turning about 800 rpm
the rating is 3.9 to 9.6 ACFM @ 175psig with a 2-3 hp motor...
Ibm wondering if it will handle a small (bench top) or small upright sand
blast cabinet without laboring it to death
any ideas if I have enough compressor ??
thanks
John
_______________________________________________
Shop-talk@autox.team.net
Donate: http://www.team.net/donate.html
Suggested annual donation $12.96
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums
Unsubscribe/Manage:
http://autox.team.net/mailman/options/shop-talk/mharc@autox.team.net
|