Probably not. My dad has a large IR 2-stage; probably a 'real' 7HP or greater
on I believe (at least) a 60-gal tank (maybe 80). It struggles to keep up with
his blast cabinet--the compressor is off for the first 5min or so of blasting,
then has to run almost continuously thereafter.
>From what I know of fluid dynamics--not much--I've always wondered what a
>large tank offers. Yes, the tank will put out more air before it reaches min
>pressure and the compressor fires, but then the compressor has to run longer
>to replace the volume of air lost.
Seems to me you need the most powerful compressor you can get, regardless of
tank size, so the compressor can replenish the tank quickly then get a rest
cycle. I think the 'HP' and 'gallons' numbers aren't particularly relevant;
what you need to know is what volume of air at what pressure the compressor can
put out (maybe that's the second set of numbers you mentioned; it's not clear
to me). The tank just 'buffers' the air flow.
Maybe a guru can enlighten us.
Bob
--------------------------------
Bob Spidell - San Jose, CA
----- Original Message -----
From: "John Niolon" <jniolon@att.net>
To: "shop-talk" <shop-talk@autox.team.net>
Sent: Friday, April 20, 2012 8:42:33 AM
Subject: [Shop-talk] compressor/sandblast guru question
Ibve got a Quincy 310 compressor sitting on a 80 gallon tank... using a 5 hp
motor. Itbs turning about 800 rpm
the rating is 3.9 to 9.6 ACFM @ 175psig with a 2-3 hp motor...
Ibm wondering if it will handle a small (bench top) or small upright sand
blast cabinet without laboring it to death
Harbor Freight rates their 40# upright model at 9.5 cfm at 90 psi..
A NESCO about the same size says 12 cfm at 80 psi...
An ATLAS says 15 cfm at 100 psi
sounds like blast cabinets are rated like lawn mower engine horsepower ratings
!!!!!
any ideas if I have enough compressor ??
thanks
John
_______________________________________________
Shop-talk@autox.team.net
Donate: http://www.team.net/donate.html
Suggested annual donation $12.96
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums
Unsubscribe/Manage:
http://autox.team.net/mailman/options/shop-talk/mharc@autox.team.net
|