I'd use one of the panel bonding adhesives, like:
http://www.nortonautomotive.com/speedgrip-auto.aspx
Bob
On 4/15/2012 2:41 PM, Dwade Reinsch wrote:
> I'm working on a project to help out my son-in-law. His "bumper" has torn off
> the front of his PT Cruiser. I've taken it off and I'm planning to buy some
> fiberglass repair tape and epoxy and rebuild the bolt holes that have torn.
> But I'd like to glue it back on when I put it back. There are several plastic
> shapers and supports behind the bumper but nothing is connected except by a
> few clips. I'd like to run a bead of glue everywhere anything touches
> anything else so the entire assembly is a bit stronger when it goes back on.
>
> This repair will NOT be taken back apart. It will stay until the car is
> totaled from the front.
>
> So, any suggestions for glue. (And I've already thought of a bunch of tubes
> of Testor's plastic glue with a needle in the tip. ) Liquid nails, etc??
>
> Thanks in advance.
> Dwade
>
>
>
> _______________________________________________
>
> Shop-talk at autox.team.net
> Donate: http://www.team.net/donate.html
> Suggested annual donation $12.96
> Archive: http://www.team.net/archive
> Forums: http://www.team.net/forums
> Unsubscribe/Manage: http://autox.team.net/mailman/options/shop-talk/bspidell
> at comcast.net
>
>
--
*******************************************************************
Bob Spidell San Jose, CA bspidell at comcast.net
*******************************************************************
|