A 'normal' box-end wrench generally has the handle attached at the top of
the box section, so that some fraction of the wrench sticks out like a
socket does. Eg, the RH side of
http://tinyurl.com/2enreg8
What I'm looking for is a ratcheting wrench that has a similar offset.
Anyone know of something like that?
The situation is a nut on a stud, with only about 1/2" clearance from the
end of the stud to a nearby frame member. The nut holds a flanged plate,
where the flange sticks up to cover about 2/3 of the nut, so an ordinary
"flat" GearWrench doesn't get a very good grip. An ordinary box end wrench
will work, but is somewhat tedious ... Ok, I'm getting lazy in my old age!
So far, this is all I've come up with:
http://tinyurl.com/24eflsk
which would do, but I'm hoping the listerati will know of some alternatives.
-- Randall
_______________________________________________
Shop-talk@autox.team.net
Donate: http://www.team.net/donate.html
Suggested annual donation $12.96
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums
|