I am trying to remove a dove tail rear iron sight so that I can install a
mount for a scope. I have made a block of wood to hold the barrel in my vice
and it holds it quite nicely. I have been using a brass punch and a pretty
big ball peen hammer to hit the punch. I have tried going both directions
with no success. I have no idea if loctite was used when the blade sight was
installed. If there was a way to super cool the sight without cooling the
barrel it might loosen it up but since the sight is so small if I put dry
ice on it the barrel would probably cool down too.
So I thought I'd see what suggestions come from the collective wisdom of
Shop-talk...any ideas?
Thanks
Gerry
_______________________________________________
Support Team.Net http://www.team.net/donate.html
Shop-talk mailing list
http://autox.team.net/mailman/listinfo/shop-talk
http://www.team.net/archive
|