Howdy,
Here's one:
http://www.northerntool.com/webapp/wcs/stores/servlet/product_6970_21896_21896
There are others out there... I looked into this one time and never found
one cheap enough for me, but I wasn't being paid to make stuff either.
Mark
On Wed, 22 Oct 2008, Doug Braun wrote:
> Yes, I have seen a bending thingie that you can put in
> a shop press. It has a bottom block with a V-groove,
> somewhere between 6 and 12 inches long, and a matching
> wedge-shaped part that the ram presses on.
>
> Look in the Grizzly, HF, northern tool, etc. web
> sites.
>
> Doug
>
>
> --- Mark J Bradakis <mark@bradakis.com> wrote:
>
>> We're not about to spend many tens of thousands of
>> dollars on
>> a fancy, full featured press brake or some such.
>> Are there other
>> alternatives? Some set of forming dies you can use
>> with a
>> typical shop press to make bends of various angles?
> _______________________________________________
> Support Team.Net http://www.team.net/donate.html
>
> You are subscribed as mark@sccaprepared.com
>
> Shop-talk mailing list
>
> http://autox.team.net/mailman/listinfo/shop-talk
>
> http://www.team.net/archive
_______________________________________________
Support Team.Net http://www.team.net/donate.html
Shop-talk mailing list
http://autox.team.net/mailman/listinfo/shop-talk
http://www.team.net/archive
|