Yes, I have seen a bending thingie that you can put in
a shop press. It has a bottom block with a V-groove,
somewhere between 6 and 12 inches long, and a matching
wedge-shaped part that the ram presses on.
Look in the Grizzly, HF, northern tool, etc. web
sites.
Doug
--- Mark J Bradakis <mark@bradakis.com> wrote:
> We're not about to spend many tens of thousands of
> dollars on
> a fancy, full featured press brake or some such.
> Are there other
> alternatives? Some set of forming dies you can use
> with a
> typical shop press to make bends of various angles?
_______________________________________________
Support Team.Net http://www.team.net/donate.html
Shop-talk mailing list
http://autox.team.net/mailman/listinfo/shop-talk
http://www.team.net/archive
|