Ummm, yeah, sure......
I'll do this to take off a thousandth or two on a thrust washer, and in fact
that's how I turned decent flat washers into relatively true-thickness shims
for the bearings, but to take off .040" or so ??
Maybe I'm just lazy ;-)
>> If you have washers that are too thick, some quality time with a grinder
>> would make them thinner... or if you can source a D-type spindle washer
>> in
>> the appropriate sizes, you could grind/file the flat into a tang.
>
> Or just some 400 grit and a flat plate - ceramic tiles are great for this
> kind of thing. Use a "figure 8" motion and measure often.
_______________________________________________
Support Team.Net http://www.team.net/donate.html
Shop-talk mailing list
http://autox.team.net/mailman/listinfo/shop-talk
http://www.team.net/archive
|