| To: | <shop-talk@autox.team.net> |
|---|---|
| Subject: | Re: [Shop-talk] Removing chuck from drill motor |
| From: | "David C." <cavanadd@verizon.net> |
| Date: | Fri, 28 Mar 2008 19:10:17 -0700 |
At 11:41 AM 3/28/2008, Randall wrote: >So I'd conclude you just need a bigger hammer ... And maybe some heat; most conventional threadlockers break down above a couple hundred degrees. DC _______________________________________________ Support Team.Net http://www.team.net/donate.html Shop-talk mailing list http://autox.team.net/mailman/listinfo/shop-talk http://www.team.net/archive |
| <Prev in Thread] | Current Thread | [Next in Thread> |
|---|---|---|
| ||
| Previous by Date: | Re: [Shop-talk] Removing chuck from drill motor, Randall |
|---|---|
| Next by Date: | Re: [Shop-talk] Removing chuck from drill motor, Carscarscarz |
| Previous by Thread: | Re: [Shop-talk] Removing chuck from drill motor, Randall |
| Next by Thread: | Re: [Shop-talk] Removing chuck from drill motor, Carscarscarz |
| Indexes: | [Date] [Thread] [Top] [All Lists] |