Sorry George, kind of vague huh. Single phase, 220v, size of shaft doesn't
matter we'll make it work. No other constraints.
George P Dausch IV <gpd4@juno.com> wrote: Voltage/phase and shaft size
requirements? Any other constraints?
GPD4
On Thu, 24 Jan 2008 09:00:02 -0800 (PST) Frank Vantacich
writes:
> I am in need of a 5hp 1725rpm electric motor for a metal lathe. Does
> any one know of a good source for something like this, it doesn't
> have to be new. So far I've seen prices ranging from 375.00 to
> 475.00 and may be this is what I will end up spending.
>
> Thanks for the help.
>
>
> Frank V.
> rustymetal@sbcglobal.net
> _______________________________________________
> Support Team.Net http://www.team.net/donate.html
>
> You are subscribed as gpd4@juno.com
>
> Shop-talk mailing list
>
> http://autox.team.net/mailman/listinfo/shop-talk
>
> http://www.team.net/archive
>
>
Frank V.
rustymetal@sbcglobal.net
_______________________________________________
Support Team.Net http://www.team.net/donate.html
Shop-talk mailing list
http://autox.team.net/mailman/listinfo/shop-talk
http://www.team.net/archive
|