My gas guy recommends a 90/10, but only if the steel is really clean. It
does work better and is a little hotter than the 75/25 when the steel is
clean, but the 75/25 is a great all steel gas.
It comes pre-mixed in one bottle.
Jack
-----Original Message-----
From: shop-talk-bounces+jibjib=att.net@autox.team.net
[mailto:shop-talk-bounces+jibjib=att.net@autox.team.net] On Behalf Of Doug
Braun
Sent: Tuesday, January 01, 2008 5:19 PM
To: nogera@worldnet.att.net; Shop Talk
Subject: Re: [Shop-talk] CO2 And Argon for MIG
I think the standard mix is 75% Argon, 25% CO2.
That's what is in my bottle.
Doug
--- Bob Nogueira <nogera@worldnet.att.net> wrote:
> I have a C02 tank for my MIG. I'm planning on doing some Aluminum work
> so I was checking on switching to Argon, My gas supplier says that I
> will need to buy a Argon tank. He also says that a 75% C02 25% Argon
> will work better for steel than 100% C02.
You are subscribed as jibjib@att.net
Shop-talk mailing list
http://autox.team.net/mailman/listinfo/shop-talk
http://www.team.net/archive
_______________________________________________
Support Team.Net http://www.team.net/donate.html
Shop-talk mailing list
http://autox.team.net/mailman/listinfo/shop-talk
http://www.team.net/archive
|