I have a C02 tank for my MIG. I'm planning on doing some Aluminum work so
I was checking on switching to Argon, My gas supplier says that I will need
to buy a Argon tank. He also says that a 75% C02 25% Argon will work
better for steel than 100% C02.
Since I have a CO2 and a Argon regulator could I hook up both bottles and
regulators ( 100% CO2 and 100% Argon) with a " Y " joint located after the
regulator and use a after tank mix?
If so any suggestions on how to get the 25 - 75 mix ratio adjusted ?
Bob Nogueira
_______________________________________________
Support Team.Net http://www.team.net/donate.html
Shop-talk mailing list
http://autox.team.net/mailman/listinfo/shop-talk
http://www.team.net/archive
|