I have had both a beam type & a clicker torque wrench for the past 20
years. I just occasionally check one against the other. They have always
read within 4% of each other & always the same differences. Maybe I have
two out of spec wrenches but have never had any problems.
Dave Russell
Kendall Jones wrote:
> You can recalibrate these clicker type wrenches through calibration services
> like www.dynamictechnology.com It costs about $50, much more than the
> wrench! I did it on a $9.99 HF special, which was almost identical to my
> $200 Proto wrench, and it was much better than 4% accurate (as I recall)
>
> Kendall
/// unsubscribe/change address requests to majordomo@autox.team.net or try
/// http://www.team.net/mailman/listinfo
/// Archives at http://www.team.net/archive/shop-talk
|