Hey guys,
I got one of these 3/4" impact wrenches a while back - what a pain - I found
that
I had to go to large ID fittings and even then it barely gives you more torque
than
"lord vader" (IR2131) on a hose of "normal" diameter (It was pretty impressive
on a chunk of "big" hose with mondo fittings though...)
- If you really want a cheap 3/4" I'll be glad to sell you mine cheap - almost
no run time and
nice sears blow molded case - after I got the 2131 I haven't used it....
(seriously!)
You might do better with a 3/4" if you buy one by a good manufacturer (IR,
etc.,) - these
seem to require much less air than the ones crafted with pride by chinese
prisoners...
Good Luck,
rkg
(Richard George)
/// unsubscribe/change address requests to majordomo@autox.team.net or try
/// http://www.team.net/mailman/listinfo
/// Archives at http://www.team.net/archive/shop-talk
|