Forwarding to list......
>From: Douglas Shook <shook@usc.edu>
>
> >
> >And finally, I got a nifty little carbon fiber do-dad for my motorcycle; an
> >exhaust heat guard. To install it requires welding 2 nuts onto the exhaust
> >pipe. The exhaust is made out of stainless steel, while the nuts, and my
> >welding setup are for plain steel. Now, this isn't really a
>
>Hi,
>
>Stainless is not really a problem if you braze it.
>Just get an acetylene torch and some fluxed, low fuming
>brazing rod, and you should be able to braze regular
>steel nuts on without any hassle.
>
>I used:
>
>Blue Demon
>LFBFC
>3/32"
>
>and brazed cracks in my motorcycle stainless steel
>fenders, brackets, and such -- worked fine.
>
>good luck,
>
>doug
Cheers!
/// unsubscribe/change address requests to majordomo@autox.team.net or try
/// http://www.team.net/mailman/listinfo
/// Archives at http://www.team.net/archive/shop-talk
|