> and $75 w/o the blaster itself (I already have that).
What kind of blaster do you have?
> I almost have my design finished but have one question. Does anyone know
a
> good source for a grate to use for the bottom of the cabinet. I was
Expanded metal scraps?
> that I haven't been able to figure out is the math to make the "funnel"
for
> the bottom to recycle. I may have to wing it and cut it out as I go. I
did
I can't imagine that being too difficult. If you think of 4 triangles, with
90-degrees on the equilateral sides (assuming a square box) then any angle
less (more acute) would produce a funnel. I'd start around 75 degrees with a
cardboard cutout and see what it looks like. Some basic trig should give
you the dimensions.
Looking forward to your next report :)
> Patton Dickson - Richmond, TX
Where's Richmond?
Rex Burkheimer
Parts Plus Marketing Director WM Automotive Whse., Fort Worth TX
Experience is the best teacher...
But her pop quizzes can be mighty tough.
///
/// shop-talk@autox.team.net mailing list
/// To unsubscribe send a plain text message to majordomo@autox.team.net
/// with nothing in it but
///
/// unsubscribe shop-talk
///
///
|