> > It's simple pV = nRT
>
> Well, sure, but plug in typical numbers for a 150 psi small shop compressor
> and tell me what values would present an outlet T of 450 degrees??
>
> I bet it's well outside the normal operating range, unless you are running
> the pump with a turbine engine :)
Like I said, I've been down this path, and I've switched from
soft solder to braze/silver solder because the soft solder melted.
Remember, this is between the compressor and the tank, not at
the tank output.
///
/// shop-talk@autox.team.net mailing list
/// To unsubscribe send a plain text message to majordomo@autox.team.net
/// with nothing in it but
///
/// unsubscribe shop-talk
///
///
|