shop-talk
[Top] [All Lists]

Re: Question about TIG

To: "Brandon Dixon" <dixon@cs.ua.edu>, <shop-talk@autox.team.net>
Subject: Re: Question about TIG
From: "Rex Burkheimer" <rex@txol.net>
Date: Thu, 27 Jul 2000 13:01:12 -0700

Is this also true when MIG welding?

>It is quite possible to
> get contamination of the weld pool from the BACK side of the metal.  Any
oil
> or grease or undercoat, etc back there can mess things up big time.
>
> Brandon Dixon
>
> -----Original Message-----
> From: Bill Ruof [mailto:1953xk@home.com]
> Sent: Thursday, July 27, 2000 8:22 AM
> To: Steven Shipley; shop-talk@autox.team.net
> Subject: Re: Question about TIG
>
>
>
> I have to add my two cents.
>
> Spatter is little BB's of metal.  If you are getting a buildup of small
> discrete balls of metal one possibility is that you are overcooking your
> weld pool.  The arc and the weld pool should be very smooth.  No sparks or
> flying metal.
>
> Take care not to contaminate the tungsten.  Once you dip it in the weld
pool
> or jam the filler against it you've contaminated it and you will start to
> get a buildup and degradation.  Snapping off the contaminated part is OK
but
> you still want to grind to shape it.  It is best to grind with a freshly
> dressed wheel.  Make sure you have a good point to start.
>
> Folks were also dead on the money about being sure that you are using the
> right filler.  Gas fillers have LOTS of deoxidizers and result in an
> overactive weld pool if used for TIG welding.  Trim your filler after a
stop
> and make sure it stays under the gas shielding while you're welding.  If
you
> pull it out from the shielding while you're welding it will oxidize.  When
> you run that oxidized metal in, you destabilize the pool and the arc.
>
> The base metal probably isn't the problem if it is ground to bright metal.
> You have to make sure to get out any pitting too.
>
> If all else fails recheck your gas lines and fittings to make sure you
> aren't drawing in any air along the way.
>
> Welding is SO much fun.
>
> Bill Ruof
>
> > I've encountered a problem.  I keep seeing a build-up of spatter
> > that sticks to the electrode and the ceramic cup.  As this spatter
> > builds up the arc becomes harder to control.  I'm spending a lot of
> > time putting new points on the electrodes.
>


<Prev in Thread] Current Thread [Next in Thread>