shop-talk
[Top] [All Lists]

Re: Question about TIG

To: shiples@home.com
Subject: Re: Question about TIG
From: "Donald H. Locker" <dhl@chelseamsl.com>
Date: Wed, 26 Jul 2000 17:56:16 -0400
Hi, Steve.

I previously said

> Distance to the work should be quite short -- on the order of 2 to 4
> mm, I would say.

I was talking about tip-of-tungsten to workpiece.  The instructions
should give you how far the tungsten should extend from the collet.

Good luck.
Donald.

<Prev in Thread] Current Thread [Next in Thread>