I wonder if flexible poly tubing would work in this case?
Ken wants it "in" the wall with outlets, for exposed piping I agree about the
galvanized pipe, but it would be difficult to put in a wall. I use the stuff
but I've never priced it, would it be cost effective?
Burl Vibert
Stephen wrote:
> Hi Ken,
>
> I set my compressor plumbing the way TIP Tools suggests. I used 3/4"
> galvanized pipe with risers and drains as they describe. I have attached a
> link to their web page that describes the plumbing set up through a link
> about half way down the page at number 5. The link was not working when I
> tried so you may want to give it a try yourself.
>
> > In any case, I am going to setup a new garage with air lines in the wall,
> > what is the best way to go? I am only going to pop in a couple of outlets
> > for it, I just want to get the compressor out of the way. From the one
|