shop-talk
[Top] [All Lists]

RE: Removing A Keyless Chuck

To: shop-talk@autox.team.net, "'jniolon@uss.com'" <jniolon@uss.com>
Subject: RE: Removing A Keyless Chuck
From: "Bedard, Justin" <justin_bedard@merck.com>
Date: Tue, 06 Jul 1999 15:00:44 -0400

Looking inside the chuck, I do see a Torx screw.  But the directions make no
mention of removing this screw.  Maybe I'll try hammering it a little harder
like Mike Sloane suggested and then attempt to remove this screw.

Thanks,
Justin

> ----------
> From:         jniolon@uss.com[SMTP:jniolon@uss.com]
> Sent:         Tuesday, July 06, 1999 1:38 PM
> To:   Bedard, Justin; shop-talk@autox.team.net
> Subject:      Re: Removing A Keyless Chuck
> 
> 
> 
> Justin,
> 
> not sure about the Dewalt brand, but many drills have a screw which holds
> the chuck onto the drill motor...  open up the chuck completely and look
> down into the chuck toward the shaft...  if you see a slotted screw it's
> probably left hand thread and must be removed before removing the chuck.
> The procedure your using is correct and it usually takes a couple of good
> licks
> AFTER the screw is removed
> 
> john
> 
> 

<Prev in Thread] Current Thread [Next in Thread>