McVintage@aol.com wrote:
>
> Suggestions wanted for removing rounded off nut where space and
> clearance around the nut are VERY limited. Its at the flange joining
> diff to prop shaft on my TR6 - on the diff side of the flange.
Nothing works like heat. If you can heat it cherry
red then throw a rag on it, it will likely be finger
tight after that. (and certainly loose enough for
a vice-grip)
I have an oxy-acetylene rig that I never use for
welding, but just the cutting and the rusty-bolt
heating has been so handy.
--
Trevor Boicey, P. Eng.
Ottawa, Canada, tboicey@brit.ca
ICQ #17432933 http://www.brit.ca/~tboicey/
|