nogera@juno.com wrote:
> When welding mild steel with a MIG set up, is there any advantage to
> using Argon or a Argon Co2 mix as apposed to CO2 ? Also my supplier
> says if I switch to argon I will have to change my regulator to a Argon
> regulator. Can use my current regulator and change out the regulator
> input fitting ?
Pure argon uses a different fitting, but you don't want
that. Use the argomix (C25).
Also, reevaluate your burn through problem when using
Argomix, you might find the problem gone.
--
Trevor Boicey, P. Eng.
Ottawa, Canada, tboicey@brit.ca
ICQ #17432933 http://www.brit.ca/~tboicey/
|