Sounds similar to the stuff that I use from Gray-Mills. I forget the
actual product name, but I get it at the local NAPA store. Its great
to use, cleans well, minimal odor, high flash point, and easy on the
hands. Again, the drawback is the price. About $50 per 5 gallons.
I hadn't mentioned it up to now, since most people wanted a lower cost
solution. My washer is also only a 5 gallon unit.
Some on this list mentioned floating the solvent on water to absorb much
of the filth and keep the costs down. Change the water more frequently
than the solvent. You just need to keep the pickup point higher in the tank.
John Miller
Nils writes:
> I have noticed that many of you on the list have complaints about parts
> washers and solvents to use in them.
>
> I have had the same problem over the years and have tried all kinds of
> solvents that smell bad to worse and don't work worth a shit. Have also
> tried to buy from SafteyKleen but is available only on a service schedule
> basis (would be OK if you needed 50 gallons every few months)
>
> The good news is the I have found a solvent that works GREAT ! Much
> better than gas-kerosene-thinners-etc. etc.
> It is available from GRANGERS and is called AGITENE available in 5 Gal
> container with almost no odor and seems gentle on the hands. Cost is $45
> but worth every penny.
>
> You can find them at http://www.grainger.com and serch for parts washer
> solvent
>
> Regards Nils
>
|