Jeff Guilford wrote:
> Does anyone know how to "balance" this type of mechanism? I assume this
> means that I have to increase the load (or pre-load?) on the springs, but
> how do I do this--without endangering life, limb, and sanity? And, how do
> you ensure that the two springs have approximately equal tension?
Doing this involves tightening the springs as you say,however as you have also
apparently figured
out,it can be very dangerous!! If you are not absolutely sure how to do it i
would seriously
consider hiring (ARRRGh what am I saying!!) a professional.
> One final note: I've had my eye on a drill press for awhile. Anyone have
> any good ideas on how to convince my wife that I can't install the garage
> door opener without benefit of this indispensable tool? ;^)
This is one of those places you have to be particularly devious.I would
suggest volunteering to do
some project for her that would be easier if you had a drill press,then
blatantly screw it up. Now
kindly explain to her that you could have done a much better job if you would
have had a drill
press,it may take a couple of attempts,but eventually she'll get the point.
Good luck
Tom
>
>
> Thanks for any help you can provide.
>
> Jeff Guilford
> Knoxville, TN
|