I did.
----- Original Message -----
From: "wayne osborne" <wayne@chevytrucks.org>
To: "Truck" <oletrucks@autox.team.net>
Sent: Tuesday, February 03, 2009 3:57 PM
Subject: [oletrucks] 235 engine
> Regarding bellhousing removal from a 235 engine, Problem is, I can't get
> the bell housing off.
> All obvious bolts have been removed, but there are two inside where the
> fly
> wheel is. Started to back them out, but if I back them out any
> farther, I'll hit the fly wheel. Do I have to remove the fly wheel first,
> then remove the bell housing?
>
> --wayne
|