Thanks Wayne. I've loojed further thru te hole ths splined shaft comes thru
the door and when I turn the shaft I can see the loose rivets holding the
shaft flange ( 3 I think ). TheShim stock wouldn't do much. I Wish the
winder mechanism could come out easier than the way the manual tells. I
should have rebuilt the winders when I did the truck in 96.----- Original
Message -----
From: "wayne osborne" <wayne@chevytrucks.org>
To: "Alan and Linda" <alquin@telus.net>; <oletrucks@autox.team.net>
Sent: Friday, January 26, 2007 10:22 AM
Subject: Re: [oletrucks] sloppy window splined shaft
>I did the same to mine, working in the printing industry I cut a couple
>small strips from plate formed it into a circle and working it in there.
>Holding up fine so far and it did remove some but not all the
>iggling.. --wayne
>
> At 01:19 PM 1/26/2007, Alan and Linda wrote:
>>Has any of you truck enthusiasts out there found a fix for loose(worn
>>bushing
>>or flange?) shaft that your window winder handle turns. I' going to try
>>make a
>>brass shim stock piece (flatstock around .020 thou.)
>
>
>
> --
> No virus found in this incoming message.
> Checked by AVG Free Edition.
> Version: 7.5.432 / Virus Database: 268.17.12/653 - Release Date: 1/26/2007
> 11:11 AM
|