Re: [oletrucks] sloppy window splined shaft

[wayne osborne <wayne@chevytrucks.org>]

Make that cut stips from a printing plate--   doh  wayne

At 01:22 PM 1/26/2007, wayne osborne wrote:
>I did the same to mine, working in the printing industry I cut a couple 
>small strips from plate formed it into a circle and working it in there. 
>Holding up fine so far and it did remove some but not all the 
>jiggling..  --wayne
>
>At 01:19 PM 1/26/2007, Alan and Linda wrote:
>Has any of you truck enthusiasts out there found a fix for loose(worn bushing
>or flange?) shaft that your window winder handle turns. I' going to try make a
>brass shim stock piece (flatstock around .020 thou.)