Are you using a double flare? Have you checked the flare for straightness
by sliding the nut up to the flare to see if it lays flat all the way around
the flare? If it keeps leaking from the same side of the tee fitting then
maybe their is something wrong with the machined surface where the flare
rests inside the tee fitting on that port. The only thing I can think of is
to replace that tee fitting. I know people don't like to use teflon tape
on the threads but I always do and it helps eliminate potential leaks.
Joe
----- Original Message -----
From: "Mark Coopet" <markc@greatlakeseng.com>
To: <oletrucks@autox.team.net>
Sent: Wednesday, February 26, 2003 11:06 AM
Subject: [oletrucks] Brakes -
> Since the demise of my near completed project I have been a bit put off.
> The gas tank cracked - leaking everywhere and the engine went out - big
> time in September. But I am in the mix again, must be spring coming or
> something.
> With the gas tank replaced, the interior redone and all working, I turn
> to where I left off, a troublesome brake line that has given me trouble
> for the past couple of months since the replacement of the whole system.
> I have one trouble spot - a "T" that splits the front end lines which
> keeps leaking, from one side. Now, I have cut and flared this line
> several times and still it seems to not fit right. I haven't replaced
> the "T" fitting and can see no evident cracks in the "T". So the short
> of it is; do I have to replace the "T"? Is my flare not matching up with
> the "T" - for that matter, how many types of flares are there and if
> there are many, could my flare tool not match that which the "T" is
> set-up for?
> Any help would be appreciated.
>
>
> Mark
> 1952 GMC 3100 1st.
> oletrucks is devoted to Chevy and GM trucks built between 1941 and 1959
oletrucks is devoted to Chevy and GM trucks built between 1941 and 1959
|