Just minor hacking....!
Hmm, now you have me wondering about the hubs on this
front end assembly. If I read you right the 1-ton front hubs
are different than the 3/4 ton hubs. The rotors are 12" in
diameter. For some reason I had thought 3/4 ton trucks had
11" rotors. I guess its time to check the hubs out closer.
Won't be able to do that though until friday when I get home.
Thanks
Brad
On 2 Dec 2002 at 12:06, Gary Perry wrote:
> HACKER problems?? One-ton dually wheels are offset quit a bit. They
> usually have an add on part on drum or rotors on front that moves studs
> out farther tho, so don't know if they would bolt up w/out that part or
> not. Maybe the hubs from 1-ton axle will work on the 3/4 spindles, not
> sure.
>
> G. L. Perry
> Huntington, IN 46750
> glperry@fwi.com
> Big AD trucks, COE
> MM tractors and 1 Oliver!
>
> ----- Original Message -----
> From: "Brad Kahler" <brad.kahler@141.com>
> To: <oletrucks@autox.team.net>
> Sent: Monday, December 02, 2002 8:56 AM
> Subject: [oletrucks] questions on a mid 70's 3/4 ton IFS swap into 1 ton
>
>
> > Ok, we've made the decision to go with a 3/4 ton mid 70's
> > IFS in our 1 ton panel. After we picked up the assembly over
> > the weekend I started taking closer dimension checks and
> > am a little stumped on a couple of things.
> >
> > The one article I read on the internet about someone
> > swapping in a 3/4 ton IFS into a 3/4 AD truck mentioned that
> > the wheel spacing was 2" wider per side that stock. As near
> > as I can tell from my measurements its more like 3.5" wider
> > per side than stock. Its a little tough to get accurate
> > measurements and what makes it even more confusing for
> > me is the fact that our truck came with 8-lug ford rims
> > (around 1992 vintage). I came up with about 58" from face of
> > brake drum to face of brake drum on our 1-ton, where as on
> > the 3/4 IFS I came up with about 65" from face of hub to face
> > of hub.
> >
> > Am I missing something here?!
> >
> > If these numbers really are correct are there replacement
> > wheels out there (16") that have more offset to help tuck the
> > wheels back under the fenders some? If so, who sells them?
> >
> > Thanks
> >
> > Brad
> > 1953 1-ton panel school bus
> > oletrucks is devoted to Chevy and GM trucks built between 1941 and 1959
> oletrucks is devoted to Chevy and GM trucks built between 1941 and 1959
oletrucks is devoted to Chevy and GM trucks built between 1941 and 1959
|