I'd try to duct the outside air into the Vintage Air unit if I were you.
Tom Allen
51 3800
At 02:04 PM 1/11/02 -0500, Jim Wilkerson wrote:
>Hello!
>
>I am resto-rodding a 53 Chevy 1/2 ton and I am using a Vintage Air
>AC/Heater unit. This leaves the original passenger side vent wide open
>(since the stock Fresh Air Heater bolted over the rectangular hole and
>controlled the air flow). I would like to put a door on the rectangular
>vent in order to allow me to open or close it as I need. Does anyone have
>a good solution for this? Is there an aftermarket vent door that will
>install over the vent? Has anyone done this?
>
>Thanks.
>
>***********************************************************************
>Jim Wilkerson
>***********************************************************************
>oletrucks is devoted to Chevy and GM trucks built between 1941 and 1959
>oletrucks is devoted to Chevy and GM trucks built between 1941 and 1959
Tom Allen
Seattle, WA
oletrucks is devoted to Chevy and GM trucks built between 1941 and 1959
|