Hello!
I am resto-rodding a 53 Chevy 1/2 ton and I am using a Vintage Air AC/Heater
unit. This leaves the original passenger side vent wide open (since the stock
Fresh Air Heater bolted over the rectangular hole and controlled the air flow).
I would like to put a door on the rectangular vent in order to allow me to
open or close it as I need. Does anyone have a good solution for this? Is
there an aftermarket vent door that will install over the vent? Has anyone
done this?
Thanks.
***********************************************************************
Jim Wilkerson
***********************************************************************
oletrucks is devoted to Chevy and GM trucks built between 1941 and 1959
oletrucks is devoted to Chevy and GM trucks built between 1941 and 1959
|