There is also additional information available for paint and bodywork on
www.autobodystore.com. They are very nice and will answer just about any
question on their BBS at the website.
Don Simmons
----- Original Message -----
From: "joe" <chevy1@jps.net>
To: <AllenHeiden@aol.com>; <oletrucks@autox.team.net>
Sent: Monday, December 03, 2001 5:13 PM
Subject: Re: [oletrucks] body work
> I think anyone that can take the time to prep the area for a close fit
with
> the donor panel and welds in short burst "spot welds" allowing the metal
to
> cool to avoid warping the metal can do the job.
>
> If your welding by yourself, you might want to invest in some Cleco
> fasteners to secure the patch panel in place while you make your initial
> tack welds so the panel doesn't move.
>
> Asking the welding supply co. for a small container of a product that
> absorbs the heat from welding to help avoid panel warpage. It comes in a
> little plastic container and it's like putty that you place close to the
> weld area and it absorbs the heat ...something like "fence heat". If
you'll
> alternate your welds from side to side and let the metal cool in between
> welding you can avoid warping the panels.
>
> Another item that helps with butt welding panels it to back up the back of
> the seam with some brass strap. The weld doesn't stick to the brass and
it
> helps to prevent burn through as well as absorbing some heat.
>
> I weld with a mig welder and when I'm doing panel repairs, I switch my
> welding spool to a .023 wire which is a smaller a diameter then my regular
> .035 wire. The smaller wire takes less heat to melt and that means less
> heat to the metal.
>
> What area's are you planning to install patch panels?
>
> Joe
> ----Original Message-----
> From: AllenHeiden@aol.com <AllenHeiden@aol.com>
> To: oletrucks@autox.team.net <oletrucks@autox.team.net>
> Date: Monday, December 03, 2001 3:54 PM
> Subject: [oletrucks] body work
>
>
> >how hard is it to do patch panels myself? have done welding myself
before.
> >have body assembly book. could i drill out old spot welds?
> >oletrucks is devoted to Chevy and GM trucks built between 1941 and 1959
> oletrucks is devoted to Chevy and GM trucks built between 1941 and 1959
oletrucks is devoted to Chevy and GM trucks built between 1941 and 1959
|