For a good example of Ray's work take a look at this link to Stovebolt.
http://www.stovebolt.com/truck/techtips/sparetire/sparetire.htm
NHJim
45 Chevy 3104
-----Original Message-----
From: owner-oletrucks@autox.team.net
[mailto:owner-oletrucks@autox.team.net]On Behalf Of Advdesign1@aol.com
Sent: Tuesday, August 28, 2001 7:17 AM
To: oletrucks@autox.team.net
Subject: [oletrucks] Re:53 Fender dimple
In a message dated 8/28/01 1:31:31 AM Eastern Daylight Time,
owner-0@autox.team.net writes:
Ray Stanley in Mass. has a kit with brackets and instructions to make the
dimple by cutting out and turning around a piece of the fender. Very
clever. I have his number at work, so call me during the day. I bought a
repro rear fender and returned it as it was incredibly thin. I'll be
sending
a review of this to the Vintage Chevy Club soon.
Bob ADler
518 733 5749
> Does anyone know if there is a source for steel rear driver side fenders
> with the spare tire dimple for 1/2 ton '53 3100 pickup? I've seen the
> steel fenders w/o the dimple, but I am not sure about with the dimple.
oletrucks is devoted to Chevy and GM trucks built between 1941 and 1959
oletrucks is devoted to Chevy and GM trucks built between 1941 and 1959
|