In a message dated 8/28/01 1:31:31 AM Eastern Daylight Time,
owner-0@autox.team.net writes:
Ray Stanley in Mass. has a kit with brackets and instructions to make the
dimple by cutting out and turning around a piece of the fender. Very
clever. I have his number at work, so call me during the day. I bought a
repro rear fender and returned it as it was incredibly thin. I'll be sending
a review of this to the Vintage Chevy Club soon.
Bob ADler
518 733 5749
> Does anyone know if there is a source for steel rear driver side fenders
> with the spare tire dimple for 1/2 ton '53 3100 pickup? I've seen the
> steel fenders w/o the dimple, but I am not sure about with the dimple.
oletrucks is devoted to Chevy and GM trucks built between 1941 and 1959
|