Tom,
My steering wheel was painted with the interior - interior color and clear
coat. I've not had good luck using the rattle can type clear coat on other
projects (peeling after a short time). I'd suggest you go ahead with your
black coats and take the wheel to a body shop as they are "always" using
clear; shouldn't cost too much to get a coat of the real stuff.
Good luck -
Emory Hodges
EEHodges@aol.com
48 Chevy 3/4 ton "Rack"
In a message dated 12/5/2000 9:10:38 PM Eastern Standard Time,
tcape@weblnk.net writes:
> Joe, I'm planning to apply a clear coat over the enamel I'm using. Should
> add to the shine. I bought "clear enamel" in the rattle can. I should be
> ready for the painting tomorrow.......so if you have any suggestions, I sure
> need them! Many thanks!
> Tom Caperton
> 47-2nd 3100....in Whiteville, NC
> tcape@weblnk.net
oletrucks is devoted to Chevy and GM trucks built between 1941 and 1959
|