In a message dated 10/23/00 7:44:31 AM Central Daylight Time,
dkrehbiel@kscable.com writes:
<< Braking system...good luck again trying to get your hucks brakes on the
front to work with the modern rear. I hear a proportioning valve will be
needed at least. I am not sure if this is a big deal or not. >>
I have Hucks in front and Bendix on the rear with a non-power dual M/C from a
Nova. I used no proportioning valve and the brakes work great. Plenty of
stopping power.
<< Drive Shaft.. You might get real lucky and find a driveshaft that is the
proper length. Probably not, so there is the expense of a custom driveshaft.>>
I used a shaft longer than I needed (none were correct length) and had it cut
down, welded and balanced for $60. No problems.
Mike Klepp
'48 3100
Wichita Falls, TX
http://www.geocities.com/mike_klepp/october_truckpage.html
oletrucks is devoted to Chevy and GM trucks built between 1941 and 1959
|