Andy:
I have RB's third brake lights on my 57 GMC. Easy to
install, just wire them in parallel with existing
tail and brake/turn lights. Depending on how straight
the ends of your bed tubes are they can be a bear to
push in and even worse to remove (nothing to hold
on to pull them out). They look great though.
I did a little extra polishing on mine before installing.
-----Original Message-----
From: Andy Johns [mailto:andy51chevy@mindspring.com]
Sent: Sunday, August 13, 2000 10:17 PM
To: oletrucks; Old Chevy Trucks
Subject: [oletrucks] How I spent my summer vacation
Hey y'all,
I just realized how far behind I am with the e-mail. I have 1164 unread
messages. Any way this summer I have purchased a '79 Impala Station wagon
for parts. I took the 350 engine, 350 Tranny, Rearend, power doorlocks,
seatbelts, rear view mirror, and middle seat. I have spent the last half of
the summer figuring out how to adapt my '87 S-15 frame to the truck. It is
going amazingly well. The rear cab mounts match the frame perfectly. I
order v8 motor mounts from JTR for the s-15 for $45 and set then engine on
the frame. The transmission crossmember fit the 350 with a fabricated
adapter plate (switch plate with holes drilled in it). I then bought a
junkyard drive shaft out of a late 70's Chevy truck and had it shortened to
64.75 inches. I also got the 5 inch fuel gauge and speedometer out of the
same truck. To get the shaft shortened here in Atlanta would cost me
$90-120. An hour and a half north of here a guy did it for $35. You just
have to shop around. The cab is mounted on the '87 frame. The bed is next.
I ordered $300 of weather-stripping, tail lights, peep mirrors and stuff
from Chevy duty. Has anyone ordered there tinted glass? It is cheaper
glass from them than any where around here. I also ordered the 3rd brake
lights from RB's that go in the bed tubes. Any experience with those? I
have had an incredible amount of good luck on this project. So far the
frame swap is working well. With school starting and being the drum major
in the marching band, time and money are running short though. I'm getting
closer to getting this thing moving though.
Andy Johns
1951 3100
oletrucks is devoted to Chevy and GM trucks built between 1941 and 1959
oletrucks is devoted to Chevy and GM trucks built between 1941 and 1959
|