In a message dated 7/31/00 8:37:22 PM Pacific Daylight Time,
merrittgene@uswest.net writes:
> I hope this is the right discussion group...
>
> Recently, there was a thread about a keeper for WD-40 spray nozzles, so I
> was amused to see another solution in the latest issue of Fine
Homebuilding.
> The reader solution they published was to drill two small holes in the
> plastic cap and thread the nozzle through the holes. The key is to place
> both holes on the same side of the cap (about 1-1/2" apart) so the nozzle
is
> slightly bent when installed.
>
> Cheap and easy...sounds good to me.
>
> Gene Merritt
> '46 Chevy pickup
Damn Gene,
That'd be a good idea if I could just find one of the caps to the cans:)
Mike
oletrucks is devoted to Chevy and GM trucks built between 1941 and 1959
|