I hope this is the right discussion group...
Recently, there was a thread about a keeper for WD-40 spray nozzles, so I
was amused to see another solution in the latest issue of Fine Homebuilding.
The reader solution they published was to drill two small holes in the
plastic cap and thread the nozzle through the holes. The key is to place
both holes on the same side of the cap (about 1-1/2" apart) so the nozzle is
slightly bent when installed.
Cheap and easy...sounds good to me.
Gene Merritt
'46 Chevy pickup
merrittgene@uswest.net <mailto:merrittgene@uswest.net>
oletrucks is devoted to Chevy and GM trucks built between 1941 and 1959
|