you also can wrap solder around the the pipe as you would if you were winding a
coil.
new mexico jim
51 two ton
50 ½ ton
"Terry S. Glines" wrote:
> Started not to mention this, but why not? =)
> There is one method of bending tubes that I have used sevral times. Cut
>the
> tube to length, then fill it good and tight with sand. Now you still want to
>go
> slow and easy on tight corners, but it will keep the line from reaching that
> dreaded "Crap! to far" point.
>
> Terry & Ace
>
> oletrucks is devoted to Chevy and GM trucks built between 1941 and 1959
oletrucks is devoted to Chevy and GM trucks built between 1941 and 1959
|