> >However they attach to the break line into a small
> >1/2 by 1 inch steel box like piece. Is this the correct way the rear
lines
> >should be connected?
>
Yes. The banjo fitting has 1/4" flare threads at one end for pipe, and a7/16
or half inch x 20 threaded bolt, Banjo bolt, going into the wheel cyl. Use
new copper washers on each side of banjo fitting on reassembly. Banjo bolt
gets rusty, but should be available at local parts store as some disc brakes
also use them. Watch length of replacement bolt.
Bob ADler
oletrucks is devoted to Chevy and GM trucks built between 1941 and 1959
|